基于DCT 級聯(lián)ICF 算法降低相干光正交頻分復用系統(tǒng)峰均抑制比

張楠，童崢嶸，張衛(wèi)華，劉葉

（天津理工大學集成電路科學與工程學院薄膜電子與通信器件重點實驗室，教育部光電器件與通信技術(shù)工程研究中心，天津 300384）

0 Introduction

Optical Orthogonal Frequency Division Multiplexing（OOFDM）technology is formed by the multicarrier modulation in the optical communication［1］.The high-speed serial data parallel transmission in OOFDM technology is accomplished by frequency division multiplexing，and provides excellent resistance to multipath fading.Since OOFDM symbols are superimposed by modulated subcarrier signals，each of the subcarrier signals has the same or similar phase，the superimposed signals are modulated with the similar original signal in phase，which results in a greater instantaneous power peak.A high Peak-To-Average Power Ratio（PAPR）are produced［2］.It is commonly believed that the high PAPR is the major disadvantage to OOFDM because high PAPR causes linear distortion of the signal through the laser［3］.Coherent Optical Orthogonal Frequency Division Multiplexing（CO-OFDM）is one of the OOFDM technology that introduced coherent light，and has a high PAPR.High PAPR can lead to degraded system performance and a number of problems such as spectral interference，signal non-linear distortion，and Bit Error Rate（BER）degradation.Signal distortion can also occur in the High-power Amplifier（HPA）area of nonlinearity［4］.

So as to settle this problem，many ways were brought up，such as Selective Mapping（SLM）［5］，Partial Transmit Sequence（PTS）［6］，clipping and filtering［7］，block coding.All of these are conventional methods，and they are roughly divided into three major categories：probability class technology［8］，signals predistortion class technology and coding class technology［9］.On the basis of traditional PAPR reduction methods，many innovative algorithms have been brought up.In 2019，AGHDAMA M H et al，proposed a PTS method based on the adaptive particle swarm optimization.Experimental results showed that the proposed method significantly had reduced the PAPR and computational complexity［10］.In 2020，BHARATI S et al，integrated the clipping method in the SLM procedure.Simulation results indicated that the offered scheme acquires the performance of appropriate PAPR reduction with low computational complexity［11］.In 2021，SHIRATO Y et al，proposed the Time Domain Sequence Superposition-selected Mapping（TDSS-SLM）scheme for PAPR suppression.The simulation results indicated that the proposed algorithm could generate superior performance at relatively computational complexity and lower implementation cost in comparison to its original algorithm［12］.

A high PAPR can generate nonlinear distortion easily in the CO-OFDM system.The nonlinear distortion can destroy the orthogonality between subcarriers，and decrease the BER.A new algorithm based on the combination of Discrete Cosine Transform（DCT）and Iterative Clipping and Filtering（ICF）is presented.

1 Principle of cascading algorithms

1.1 ICF algorithm principle

Among the methods to reduce the signal PAPR，the clipping and filtering algorithm is one of the signals predistortion class technology，which can simply and effectively achieve the goal of reducing the PAPR，the computational complexity and redundancy are relatively low，but the clipping and filtering is a nonlinear processing of the signal，it will cause the signal distortion and BER increase.

When the amplitude|xn|of the time domain signalxn=|xn|ejφnafter the IFFT is greater than the threshold valueA，the amplitude can be set to the threshold value，the phaseφnremains unchanged；and the amplitude|xn|is less than the threshold value，it is allowed to pass without any processing.Theynfor the amplitude limit is given as follows［13］

In general，the limit level is expressed by the Clipping Ratio（CR）［14］，CR=20lgwhere，σis the root average square of the signal power，Ais a threshold value.

However，the clipping actually changes the amplitude characteristics of the signal in the time domain.This also means that noise is introduced into the system.This kind of noise will not only create in-band signal distortion，it will also cause out-of-band spectral dispersion，which has a great influence upon the system capability.This kind of phenomenon can be observed in Fig.1，when the CR value is 3，4，5 respectively，with the CR value decreases，the signal distortion becomes more serious.

The ICF algorithm is a modified clipping and filtering algorithm，which is accomplished by repeating the process of the clipping and filtering algorithm several times.In addition，each clipping and filtering process requires an IFFT and FFT transform.At the same time，another IFFT transform is performed on the signal，IFFT will transform frequency domain signal to time domain signal.

1.2 Discrete cosine transform principle

DCT is an orthogonal transform with good sideband properties，likewise to the Hadamard transform method.To decrease the PAPR of CO-OFDM signals，the input signal is first used a DCT to reduce the probability of large peaks，before entering the IFFT module.The reduction of the signal PAPR can be achieved in CO-OFDM by using its feature of reducing the correlation of the input sequence.The one-dimensional DCT with sampling point ofNis expressed as［15］

The one-dimensional IDCT with sampling point ofNis given below

The value ofa(k)is expressed as

The one-dimensional DCT of sampling pointNshown in Eq.（2）can also be written in matrix form，where the row or column vectors of the DCT matrix are all orthogonal.

1.3 PAPR problem for CO-OFDM system

From the previous introduction we already know that high PAPR is an important issue in CO-OFDM systems，and in CO-OFDM system，the value of PAPR is defined as the specific value of the largest instantaneous power over the mean power within a CO-OFDM symbol，which can be presented in the following way

where，E[ ·] is the math expectations，the time domain output signalxk［16］is obtained by IFFT andL-fold oversampling of continuous signalx(t)

whereXndenotes the data symbol over first subcarrier，Nstands for the number of subcarriers，and the symbol period isT，Δf=1/(NT)is the subcarrier frequency interval andLis the sampling multiplier.

In a multicarrier modulation system，the Complementary Cumulative Distribution Function（CCDF）indicates the probability of the average value of the peak over a certain threshold PAPR0.Therefore，CCDF can measure the distribution of the signal PAPR when it is required to express a CO-OFDM signal PAPR value，which can be represented by the following［17］

1.4 Principle of DCT-ICF algorithm

The algorithm schematic of the presented scheme of DCT-ICF cascade in this paper is illustrated in Fig.2.

The algorithm is performed in the following steps：

1）The raw dataXis input，the data sequence is transformed to several low-speed parallel data through serial-to-parallel（S/P）conversion.Moreover，the parallel data is QPSK modulated，which isX0，X1，X2，…，XN-1.

2）DCT is performed on the generated signal，thus reducing the PAPR，which is the Eq .（2），after the IFFT.

3）The signal is subjected to IFFT operation to achieve the modulation process of the CO-OFDM complex equivalent of the baseband signal.

4）With the completed of IFFT，a parallel-serial（P/S）conversion is performed and the signal is the input signalX'for the ICF algorithm.

5）Signal enters the circulation of the ICF algorithm and passes through the IFFT，which converts the frequency domain signalX'into time domain signal.The signal is clipped and filtered，and the time domainis converted into frequency domainduring the FFT transformation.is filtered by several times of clipping to obtain.

2 Simulation and result analysis

The system of CO-OFDM with DCT-ICF scheme is shown in the functional block diagram of Fig.3.It consists of five major parts，namely the CO-OFDM transmitter module，the Radio Frequency（RF）-to-optical upconverter module，the optical channel module，the optical-to-RF downconverter，and the CO-OFDM receiver module.The system is built by Optisystem and MATLAB.

In this article，both the results of simulation and the algorithm capability are evaluated to demonstrate the effectiveness for the DCT-ICF scheme in CO-OFDM system.The major experimental parameters of the simulation are established as follows：the transmission rate of the system is 50 Gb/s；the amount of subcarriers is 256，signal is modulated by QPSK modulation；OFDM symbol is 200 in length；signal sequence number is 10 000；the frequency of the Continuous Wave（CW）laser at the transmitter is 193.1 THz，the linewidth of the CW laser is 0.01 MHz；the optical amplifier has a gain with 16 dB，noise figure is 3.2 dB.

2.1 Time domain waveform

As displayed in Fig.4，the time domain waveforms of the original signal and the processed signal with DCT-ICF algorithm are shown.Fig.4（a）indicates the original signal time domain waveform，with a peak value of 4.485.As displayed in Fig.4（b），after the DCT-ICF algorithm，the peak value of the time domain waveform is 3.273，which is 1.212 less than the original signal.This result indicates that DCF-ICF algorithm has the ability to suppress PAPR.

2.2 PAPR performance analysis

As shown in the Fig.5（a），when the CCDF is 10-4，the CCDF curve of the DCT algorithm shows that the PAPR0value of the original signal is 11.48 dB.After DCT，the PAPR0value is 8.022 dB，and the PAPR0value of the signal after DCT is optimized by 3.458 dB.The results show that DCT can effectively cut down the signal PAPR.

Fig.5（b）demonstrates the CCDF curve of ICF algorithm for diverse iteration numbers and the vertical coordinate is the CCDF value.When CCDF is 10-4and CR is 4，with the gradual increase in the iteration numbers，PAPR0value of the presented algorithm also decreases successively，which are 8.763 dB，7.571 dB，6.93 dB，6.559 dB，6.31 dB and 6.205 dB.The filtering operation will cut down the out-of-band interference in the spectrum of the signal.However，it can also cause severe regeneration of peaks.Thus，the presented algorithm requires several iterations to accomplish the suppression of PAPR.

As shown in Fig.5（c），this figure demonstrates the CCDF curves for the original signal，DCT algorithm and DCT-ICF algorithm at CR is 3，4 and 5.And in the presence of CCDF is 10-4，the value of PAPR0corresponding to the original signal，DCT，DCT-ICF（CR=3，iter=4），DCT-ICF（CR=4，iter=4）and DCT-ICF（CR=5，iter=4）algorithms are 11.48 dB，8.112 dB，5.759 dB，6.795 dB and 7.615 dB separately.The results show that the joint algorithm of DCT-ICF has a stronger ability to suppress PAPR than the DCT algorithms.

2.3 Analysis of BER

Transformation curve of BER with Optical Signal to Noise Ratio（OSNR）variation for the joint DCTICF algorithm is displayed in Fig.6（a）.The BER decreases with the increasing of OSNR.The higher the CR value，the higher the BER.It can be seen when the BER is 10-3，the CR is 3，4 and 5 respectively，the corresponding OSNR values are 20.76 dB，20.96 dB and 21.47 dB separately.BER of the joint algorithm varies with the length of the SMF as display in Fig.6（b），and as the Single Mode Fiber（SMF）length increases from 320 km to 880 km，the BER keeps increasing，in the meanwhile，the BER increases with larger CR values.

2.4 Computational complexity analysis

The calculation complexity for each algorithm is mainly expressed in terms of the multiplication calculation amount and addition calculation amount that are required for the FFT/IFFT.DCT algorithm requires two operations of DCT and IDCT.The computational complexity of the three algorithms is obtained in Table 1.Table 2 demonstrates the computational amount of different algorithms atN=256 and iter=4.The total computational cost of the proposed algorithm is 19 970.

Table 1 Computational complexity of different algorithms

Table 2 Computational amount of different algorithms at N=256 and iter=4

3 Conclusion

In this paper，taking into account the PAPR and BER，a cascade algorithm of DCT and ICF is put forward to decrease the PAPR of CO-OFDM system.Simulation results demonstrate that the algorithm can accomplish effective PAPR suppression in CO-OFDM systems and maintain good BER compared to the DCT algorithm.The presented algorithm sacrifices a small amount of computational complexity compared to the conventional ICF algorithm，achieves the PAPR reduction and ensures the BER performance.In summary，the proposed algorithm has certain feasibility.