高壓下不同載氣多原料超濃相氣力輸送機理及流動特性研究

陳曉平　梁財　趙長遂　龔欣　郭曉鐳

摘 要：為了獲得高壓濃相氣力輸送過程中不同粉體的輸送機理及流動特性，對發料罐內的流動特性、不同粉體的輸送特性及含水率對流動穩定性的影響規律進行實驗研究并進行數值模擬。引用先進的陣列式靜電傳感器對粉體流動過程的特征參數進行監測。結果如下：采用光纖顆粒濃度探針獲得了常壓上出料式發送罐內提升管入口附近區域顆粒濃度分布，揭示了提升管入口附近區域氣固流動結構的變化規律。在高壓超濃相條件下進行了不同含碳原料的氣力輸送實驗研究，獲得了褐煤、無煙煤以及石油焦的輸送規律，發現了石油焦輸送過程中的結殼問題并提出了解決方法；通過褐煤中不同賦存形態的水分進行分類研究，獲得了不同褐煤氣力輸送臨界水分含量。對工業規模級豎直上升管壓降進行了研究，并對粉煤密相氣力輸送管路流型及其壓力信號特征分析，揭示了粉煤流動穩定性以及流型變化特性。對基于顆粒動理學理論的雙流體模型進行了修正，建立了描述常壓上出料式發送罐內氣固流動的數學模型，獲得了提升管入口附近區域顆粒濃度和速度分布規律?；陔p流體Euler-Euler方法，將k-ε-kp-εp湍流模型與顆粒動理學理論相結合，對高壓超濃相粉體氣力輸送的氣固兩相流的全面力學分析，通過對氣固兩相流的動力學參數的瞬態分布特征的理論分析，對原有數理模型進一步的改進和完善后，利用此模型對高壓超濃相輸送系統中水平管、彎管和垂直管建立了完善的一體化管道并進行模擬計算。開發了基于陣列式靜電傳感器的多路相關速度測量系統，實現了顆粒局部平均速度的測量，并將其應用于高壓濃相煤粉氣力輸送的過程監測中，為提高氣力輸送效率和輸送穩定性提供參考依據。

關鍵詞：高壓 濃相 氣力輸送 多原料 載氣 流動特性

Abstract：In order to obtain conveying mechanisms and flow characteristics of dense-phase pneumatic conveying at high pressure， experimental study and numerical simulation on discharge characteristics of blow tank， conveying experiments of different carbonaceous powders and moisture content were performed. Advanced electrostatic sensor arrays were used to monitor powder flow characteristic parameters during conveying process. The results are as follows： an optical fiber particle concentration probe was utilized to obtained particle concentration distribution near the inlet of top discharge feeding hopper under normal pressure， which reveals the variation regularity of gas-solid flow structure in the region near the lift pipe inlet. Under the condition of high-pressure ultra-dense phase， different carbonaceous particles of lignite， anthracite and petroleum coke pneumatic conveying experiments were conducted to find their conveying regularities， and crusting and its solution were found during conveying petroleum coke； classifying study on various modes of occurrence of water in lignite got different critical moisture content during pneumatic conveying. Pressure drop of vertical lifting pipe of industrial scale was studied， and the flow pattern of dense-phase pulverized coal in pneumatic pipe and its characteristics on pressure signal was analyzed. Based on the two-fluid model of particle kinetic theory was amended to establish a mathematical model describing the material type sent out on the solid flow tank pressure，get the riser near the entrance area of particle concentration and velocity distribution.Based on the two-fluid Euler-Euler method， the k-ε-kp-εp turbulence model and the particle kinetic theory by combining ultra- dense high-pressure phase of comprehensive mechanical pneumatic conveying of powders phase flow analysis by gas-solid distribution of transient two-phase theory of kinetic parameters of the analysis， the original mathematical model to further improve and refine the use of this model for ultra- high pressure dense phase conveying systems level， bends and vertical pipes to establish a sound integrated pipeline and simulation.Developed a multi-channel correlation velocity measurement system based on electrostatic sensor array，to achieve local average particle velocity measurements， and apply process high pressure dense phase pneumatic conveying of pulverized coal monitoring.

Key Words：High-pressure；Dense-phase；Pneumatic conveying；Carbonaceous powder；Carrier gas；Flow characteristics

閱讀全文鏈接（需實名注冊）：http：//www.nstrs.cn/xiangxiBG.aspx？id=48698&flag=1